Ignition system components, removing and installing
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2005 Volkswagen Jetta, 2005 Volkswagen GTI, 2004 Volkswagen Jetta, 2004 Volkswagen GTI, and 2003 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
1 - Connector
- Black, 4 pin
2 - Ignition coil with output stage v N70 , Ignition coil with output stage N127 , Ignition coil with output stage N291 , Ignition coil with output stage N292
- Checking → Ignition coils with output stage, checking
- For removing use only removal tool T40039 → Ignition coils with output stage, checking
3 - Circlip
- For Camshaft Position (CMP) sensor G40
4 - Spark plug, 30 Nm
- Remove and install with 3122B
- Type and electrode gap → Test data, spark plugs , test data, spark plugs
5 - Connector
- Black, 3-pin
- Sensor and connector contacts are gold-plated
6 - Bolt, 10 Nm
7 - Camshaft Position (CMP) sensor G40 *
8 - Bolt, 25 Nm
9 - Washer
- Conical
10 - Hood
- For Camshaft Position (CMP) sensor G40
- When installing note fixing arrangement
11 - Bolt, 20 Nm
- Tightening torque influences the function of the knock sensor
12 - Knock sensor (KS) 1 G61 *
- Sensor and connector contacts are gold-plated
- Location: Cylinder block intake side
- Checking → Knock sensor, checking
13 - Knock sensor (KS) 2 G66 *
- Sensor and connector contacts are gold-plated
- Location: Cylinder block intake side
- Checking → Knock sensor, checking
14 - Connector
- 2-pin
- Contacts gold plated
- Black for knock sensor (KS) 1 G61
- Black for knock sensor (KS) 2 G66
- Mark connector before removing
15 - Ground wire
- Only loosen or tighten with ignition switched off
16 - Bolt, 10 Nm
- Only loosen or tighten with ignition switched off