LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2006 >> GTI 1.8 E, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 107 (1.8L - Fuel Injection Ignition, Engine Code(S): AWW, AWP (A4 Platform)) >> 01 On Board Diagnostic (OBD) >> Output Diagnostic Test Mode >> Output Diagnostic Test Mode (function 03), performing >> Test conditions

Test conditions

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2005 Volkswagen Jetta, 2005 Volkswagen GTI, 2004 Volkswagen Jetta, 2004 Volkswagen GTI, and 2003 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Main Fuse Panel
GW00000097Courtesy of VOLKSWAGEN UNITED STATES, INC.
NOTE:
  • The Output Diagnostic Test Mode can only be carried out if the engine is stationary and ignition switched on.
  • The Output Diagnostic Test Mode will be broken off if the engine is started or a rotational impulse is recognized.
  • During the Output Diagnostic Test Mode the individual final controls will be activated until advancing to the next final control by pressing the → button.
  • The final controls are checked acoustically or by touching.
  • If it is necessary to repeat the Output Diagnostic Test Mode, without first running the engine briefly, switch the ignition off for approx. 2 seconds.
  • The electric fuel pump will run during the complete Output Diagnostic Test Mode.
  • The Output Diagnostic Test Mode will be aborted after 10 minutes.
scientia non olet · About LEMON Manuals