Functional check:

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2005 Volkswagen Jetta, 2005 Volkswagen GTI, 2004 Volkswagen Jetta, 2004 Volkswagen GTI, and 2003 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Switch ignition on: Malfunction Indicator Lamp (MIL) must light-up.

If the Malfunction Indicator Lamp (MIL) does not light-up with ignition switched on:

Check combi-instrument and EPC warning lamp as follows: → 01 ON BOARD DIAGNOSTIC (OBD)

If Malfunction Indicator Lamp (MIL) lights-up with ignition switched on, continue check as follows:

Start engine and run at idling speed: Malfunction Indicator Lamp (MIL) must go out after a few seconds.

If the Malfunction Indicator Lamp (MIL) does not go out:

Check DTC Memory, if necessary, repair any malfunctions and then Erase DTC Memory → DTC memory (functions 02 and 05), checking and erasing
Read readiness code → Readiness code, reading . If the DTC memory has been erased, the readiness code must be generated again

Engine code AWW, → Readiness code for engine code AWW, generating

Engine code AWP, → Readiness code for engine code AWP, generating