LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2006 >> GTI 1.8 E, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 107 (1.8L - Fuel Injection Ignition, Engine Code(S): AWW, AWP (A4 Platform)) >> 01 On Board Diagnostic (OBD) >> Measuring Value Block >> Measuring value blocks, evaluating display groups 50 to 69 (Speed regulation) >> Display group 50 (Speed regulation) Operating condition

Display group 50 (Speed regulation) Operating condition

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2005 Volkswagen Jetta, 2005 Volkswagen GTI, 2004 Volkswagen Jetta, 2004 Volkswagen GTI, and 2003 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
Display group 50 (Speed regulation) Operating condition
  • Engine running at idling speed
Read Measuring Value Block 50 Indicated on display    
xxxx RPM xxxx RPM Text Text      
1 2 3 4 Display zones Specification Evaluation
        Air conditioner compressor operating mode ON/OFF Compr. ON or Compr. OFF ---
      Air conditioner operating mode A/C-High or A/C-Low ---
    Engine speed (idling speed specification): Manual transmission Automatic transmission 760 RPM 700 RPM ---
  Engine speed (idling speed): Manual transmission Automatic transmission 700 to 820 RPM 640 to 760 RPM  
NOTE:
  • For display zone 2:
  • The specified engine speed from engine control module (calculated in control module) is displayed. In exceptional cases the idling speed can be adapted → Idling speed, adapting  . The idle speed figures with gear selected are then automatically modified.
NOTE:
  • For display zone 3:
  • A/C-High = Air conditioner demands too high a heating or cooling output A/C-Low = Air conditioner not switched on.
NOTE: