LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2006 >> GTI 1.8 E, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 101 (3.2L VR6 4V Engine Mechanical, Fuel Injection Ignition, Engine Code(S): BJS) >> 20 - Fuel supply >> Fuel supply system components, removing and installing >> Fuel supply system components, removing and installing

Fuel supply system components, removing and installing

WARNING: This page is about a different car, the 2004 Volkswagen R32. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Hose connections are secured with either spring-type or clamp-type clips.
  • Always replace clamp-type clips with spring-type clips.
  • Fuel hoses at engine must only be secured with spring-type clips. The use of clamp or screw type clips is not permissible.
  • The spring-type clip pliers VAS 5024A are recommended for installing spring-type clips.

Fuel tank with attachments and fuel filter - assembly overview, refer to Fuel tank with attachments and fuel filter, assembly overview 

Observe safety precautions, refer to Safety precautions when working on fuel supply system  .

Note rules of cleanliness, refer to Rules for cleanliness 

Suction jet pump, removing and installing, refer to Suction jet pump, removing and installing  

Fuel delivery unit, removing and installing, refer to Fuel delivery unit, removing and installing  

Fuel level sensor, removing and installing, refer to Fuel level sensor, removing and installing  

Fuel tank, removing and installing, refer to Fuel tank, removing and installing 

Observe crash fuel shut-off, refer to Crash fuel shut-off 

Check fuel pump, refer to Fuel pump, checking 

Checking fuel delivery

Checking fuel pump non-return valve

scientia non olet · About LEMON Manuals