LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2006 >> GTI 1.8 E, Automatic >> Repair and Diagnosis >> Electrical >> Gauges >> Electrical Equipment - General Information (A4 Platform) >> 97 - Wiring >> Wiring Harnesses and Connectors, Repairing >> Wiring harnesses, repairing >> Notes

Wiring harnesses, repairing: Notes

NOTE:
  • Observe general notes for repairs on the vehicle electrical system. Refer To Vehicle electrical system, general repair notes  .
  • Not all the wire cross-sections installed in the vehicle are contained in the Wiring Harness Repair Kit VAS1978 or Wiring Harness Repair Set VAS1978A. If the required wire cross-section is not present, the next greater cross-section must be used.
CAUTION:
  • Note specific CAN-Bus wiring repair measures.
  • Note specific primary and secondary terminal and connector repair measures. Refer To Terminal housings, releasing and disassembling 
  • Soldering is not permitted!
  • Do not repair welded connections in the wiring harness. Fabricate and connect an appropriate overlay harness instead.
  • Wiring harness and connector repairs must only be performed using VAS 1978 Wiring Harness Repair Kit VAS 1978 Instruction Manual.
  • Only the yellow repair cables and insulation tape supplied with VAS 1978 are to be used for wiring/connector repairs. The use of yellow repair wires and yellow insulation tape identifies that a repair has taken place.
  • All shielded wiring (e.g.: knock sensors, antenna etc.) are Not to be repaired! Replace complete wiring harnesses as necessary.