Parallel movement, adjusting
NOTE:
- Parallel movement adjustment can only be performed with drive motor removed and glass panel (in zero position).
- Removing drive motor for sunroof. Refer to Drive motor for sunroof, removing .
Fig 1: Identifying Marking On Upper Part Of Rear Guide Between Markings Dimension At Slotted Guide Rail
Marking - arrow - on upper part of rear guide - 1 - must be located on both sides between markings dimension - a - at slotted guide rail - 2 -.
Slotted guide rail - 2 - must be engaged in guide rail (cannot be moved by hand).
- Slide upper part of guide - 1 - only from front toward rear center, between markings.
- Install drive motor (zero position) in this position.
Then check zero position.