Needle lift sensor G80 , checking: Notes
WARNING: This page is about a different variant/trim than selected.
The needle lift sensor signal is used to determine the start of injection. If it fails the start of injection switches to open-loop control (using engine speed and engine load). During normal operation the start of injection is controlled by a closed-loop function (using engine speed, engine load and engine coolant temperature).
NOTE:
- The gold-plated contacts must be used to repair terminals in the connector for the needle lift sensor G80.
Special tools, testers and auxiliary items required
- Test box VAG1598/31
- Hand multimeter VAG1526A or Multimeter VAG1715
- Adapter set VAG1594
- Wiring diagram