Work sequence

WARNING: This page is about a different variant/trim than selected.

Connect Scan Tool (ST) VAS5051 using adaptor cable VAS5051/1 or VAS5051 /3 as follows:

Fig 1: Connecting Scan Tool VAS5051 using adaptor cable VAS5051/1 To Data Link Connector

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Push adaptor cable into Data Link Connector (DLC).
Depending on function: Turn on ignition or Start engine: Selectable functions, when using Scan Tools (ST) VAG1551 /1552 or VAS5051 , Table "Selectable functions".

NOTE:

In the functions 04 - Basic setting/08 - Read data block, the display zones will be listed from top to bottom.
If the display does not indicate as described in the work sequence: Operating instructions for Vehicle Diagnosis, Testing and Information System VAS5051.