Display group 004 at Wide Open throttle (WOT), test drive in 3rd gear, Engine Coolant Temperature 80 ° C (176 ° F) minimum
WARNING: This page is about a different variant/trim than selected.
NOTE:
- When testing, accelerate vehicle at WOT.
- Measured values must be printed or displayed (2nd person required) when engine speed reaches 3,000 RPM.
- Observe safety precautions when performing test drive → Safety precautions .
| Display group 004 -Start of injection- | ||||||
| Read Measured value block 4 | → | Indicated on display | ||||
| xxxx RPM | xx.x ° B/ATDC | xx.x ° B/ATDC | xxx % | |||
| 1 | 2 | 3 | 4 | Display zones | Specification | Evaluation |
| Cold Start Injector Duty cycle | 50...95% | Evaluation: Start of injection (actual) display | ||||
| Start of injection (actual) | Approx. Start of inj. (specified) | Evaluation: Start of injection (actual) display | ||||
| Start of injection (specified) | 8.0...14.0 ° BTDC | --- | ||||
| Engine speed (RPM) | 2900...3100 RPM | --- | ||||