Work sequence
WARNING: This page is about a different variant/trim than selected.
- Connect Scan Tool (ST) VAG1551 /( VAG1552 ). With engine idling select Engine Control Module (ECM) with "Address word" 01 (Connecting Scan Tool (ST) and selecting ECM → Scan Tool VAG1551 , connecting .
Indicated on display:
| Rapid data transfer HELP Select function XX |
- Operate Scan Tool (ST) and advance through program sequence by following display.
- Press buttons 0 and 3 for "Output Diagnostic Test Mode" (DTM).
Indicated on display:
| Rapid data transfer Q 03 Output Diagnostic Test Mode (DTM) |