Activating Malfunction Indicator Lamp (MIL) and Switch K82 :
WARNING: This page is about a different variant/trim than selected.
- Press → button.
Indicated on display:
| Output Diagnostic Test Mode → Malfunction Indicator Lamp (MIL) |
MIL must flash.
MIL does not flash:
- Check Malfunction Indicator Lamp (MIL) and Switch K82 : → Electrical Wiring Diagrams, Troubleshooting and Component Locations
- Press → button.
Indicated on display:
| Rapid data transfer HELP Select function XX |
- Press buttons 0 and 6 for "End output" and confirm with Q button.
- Switch off ignition.