Tightening Specifications

Fig 1: Identifying Engine Mount Components

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

1 - 40 Nm + 90° (1/4) additional turn ¹

2 - 20 Nm + 90° (1/4) additional turn ¹

3 - 60 Nm + 90° (1/4) additional turn ¹

• ¹ Always replace

Fig 2: Identifying Transmission Mount & Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

A - 40 Nm + 90° (1/4) additional turn ¹

B - 60 Nm + 90° (1/4) additional turn ¹

• ¹ Always replace

Fig 3: Identifying Pendulum Supports & Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

A - Strength category 8.8 = 40 Nm + 90° (1/4) additional turn ¹

A - Strength category 10.9 = 50 Nm + 90° (1/4) additional turn ¹

B - 100 Nm + 90° (1/4) additional turn ¹

Removing: first remove the bolt -B-, then the bolts -A-.

Installing: first install the bolts -A-, then the bolt -B-.

• ¹ Always replace