Tandem pump, removing and installing: Notes
WARNING: This page is about a different variant/trim than selected.
CAUTION:
- The fuel and the fuel lines in the fuel system can become very hot (danger of scalding)!
- The fuel system is also under pressure! Before opening the system, place cloths around the connection. Then carefully loosen the connection to release the pressure.
- Wear eye and hand protection when performing any type of repair work on the fuel system!
Special tools, testers and auxiliary items required
- Torque wrench (5...50 Nm) V.A.G 1331
- Hand vacuum pump V.A.G 1390
- Bleed container V.A.G 1390/1
- Spring-type clip pliers V.A.G 1921