Oil pan, removing and installing: Removing

WARNING: This page is about a different variant/trim than selected.

Remove center, left and right sound insulation trays: → Body Exterior - Repair Group 50
Drain engine oil.

NOTE:

Observe disposal regulations!

Remove securing bolts for oil pan.
Loosen oil pan with light blows of a rubber-headed hammer, if necessary.
Remove oil pan.
Remove sealant residue on cylinder block with a flat scraper.

Fig 1: Removing Sealant Residue From Oil Pan With A Rotating Brush

GW00000130

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove sealant residue on oil pan with a rotating brush, e.g. a drill motor with a plastic brush (wear eye protection).
Clean sealing surfaces. Surfaces must be free of oil and grease.