Installation sequence
WARNING: This page is about a different variant/trim than selected.
Removing
- Remove sound insulation.
- Position drip tray V.A.G 1306 underneath.
- Remove air cleaner housing.
- Remove union nut - 2 - or banjo bolt - 4 - from oil filter bracket.
- Remove bolt - 6 -.
- Remove union nut - 2 - on turbocharger.
- Remove bolt - 9 - from bracket - 7 -.
- Remove nut - 8 - and take off bracket - 7 -.
- Remove oil supply line - 1 -.
Installing
Installation is performed in reverse order of removal. Note the following:
CAUTION:
The installation of the oil supply line must be as described below.
- Screw bracket - 7 - with nut - 8 - loosely to exhaust manifold.
- Install union nut - 2 - or banjo bolt - 4 - on oil filter bracket.
- Install union nut - 2 - on turbocharger.
- Tighten union nut - 2 - or banjo bolt - 4 - on oil filter bracket to specified torque.
- Tighten union nut - 2 - on turbocharger to specified torque.
- Position clips - 5 - on oil supply line.
- Tighten bolts - 6 - and - 9 - to specified torque.
- Tighten nut - 8 - to specified torque.