Camshaft oil seal, removing and installing: Installing
WARNING: This page is about a different variant/trim than selected.
NOTE:
- The oil seal sealing lip must not be additionally oiled or greased.
- Remove oil residue from camshaft journal with a clean cloth.
- Tape over (e.g. with cellophane tape) groove in taper of camshaft.
- Position oil seal carefully on camshaft.
- Press in oil seal with press piece of puller 10-203 and bolt M12 x 65 onto limit stop.
- Install toothed belt and tension. Refer to Toothed belts, removing, installing and tensioning .