Cylinder head, removing and installing: Notes
WARNING: This page is about a different variant/trim than selected.
Special tools, testers and auxiliary items required
- Drip tray V.A.G 1306
- Torque wrench (5 to 50 Nm) V.A.G 1331
- Torque wrench (40 to 200 Nm) V.A.G 1332
- Hand vacuum pump V.A.G 1390
- Bleed container V.A.G 1390/1
- Bracket T10014
Special tools, testers and auxiliary items required
- Support device 10-222A with legs 10-222A/13
NOTE:
- All cable ties which are opened or cut through when the cylinder head is removed must be replaced in the same position when the cylinder head is installed.
CAUTION:
When doing any repair work, especially in the engine compartment, pay attention to the following due to the cramped conditions:
- Route all the various lines (e.g. for fuel, hydraulics, EVAP system, coolant, refrigerant, brake fluid and vacuum) and electrical wiring in their original positions.
- Ensure that there is sufficient clearance to all moving or hot components.