Checking ring gap
WARNING: This page is about a different variant/trim than selected.
Special tools, testers and auxiliary items required
- Feeler gauges
Work sequence
- Push ring squarely from above down to approx. 15 mm from bottom end of cylinder.
- Determine ring gap using feeler gauges.
| Piston ring Dimensions in mm | new | Wear limit |
| 1. compression ring | 0.20 to 0.40 | 1.0 |
| 2. compression ring | 0.20 to 0.40 | 1.0 |
| Oil scraper ring | 0.25 to 0.50 | 1.0 |