Tightening sequence for compact bracket to cylinder block

Fig 1: Tightening Sequence For Compact Bracket To Cylinder Block

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Tightening sequence for compact bracket to cylinder block

Work sequence

• Position compact bracket on cylinder block (observe dowel sleeve between compact bracket and cylinder block).
• Tighten compact bracket as shown in following tightening sequence:

1. Tighten bolt A , 45 Nm
2. Tighten bolt B , 45 Nm
3. Tighten bolt C , 45 Nm
4. Tighten bolt D , 45 Nm
5. Tighten bolt E , 45 Nm
6. Tighten bolt F , 45 Nm