Removing and installing sender wheel

WARNING: This page is about a different variant/trim than selected.

Fig 1: Removing And Installing Sender Wheel

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Replace sensor wheel - 2 - each time bolts - 1 - are loosened. Tightening torque: 10 Nm plus an additional 90 ° ( 14 turn)

NOTE:

The second time the bolts are tightened, the contact point of the countersunk head, in the sender wheel, is deformed sufficiently to allow the bolt head to seat - arrows - on the crankshaft - 3 - , thus allowing the sender wheel to remain loose under the bolts.