Engine and transmission mountings, aligning

WARNING: This page is about a different variant/trim than selected.

CAUTION: The assembly must be supported with the support device 10-222A before loosening the bolts.

Fig 1: Measuring Engine Mounting

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Engine assembly mounting

a = 14.0 mm

b = At least 10.0 mm

Both bolt heads - 1 - must be in flush with edge - c -.

Fig 2: Measuring Transmission Mounting

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Transmission assembly mounting

The edges - a - and - b - must be parallel with one another.

c = 18 to 20 mm