Crankshaft Seal, Transmission Side: Installing

-- Clean the sealing surfaces. They must be free of oil and grease.

-- Before installing, remove any remaining oil from the end of the crankshaft with a clean cloth.

-- Insert the assembly device T10122/1 onto the pull sleeve T10122/2 and slide the seal -A- onto the pull sleeve.

Fig 1: Identifying Seal, Sleeve T10122/1 And Assembly Tool T10122/2

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the assembly device T10122/1.

-- Install the pull sleeve T10122/2 with the seal -A- onto the crankshaft.

Fig 2: Identifying Installation Of Pull Sleeve T10122/2 With Sealing Ring Onto Crankshaft

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Press in the seal all around evenly and flush using the pressure sleeve T10122/3.

The rest of the installation follows the reverse of the removal procedures. When doing this note the following:

• Remove the locking pin T40069 from the rear of the cylinder block and install the locking bolt.