With The Fuel Delivery Unit Installed
Special tools and workshop equipment required
- Fuel Extracting Adapter VAS 5190/3
- Test Instrument Adapter/DSO (5-pin) VAS 5565
- Remote Control V.A.G 1348/3A
- The fuel supply line is under pressure. Always wear protective eyewear and protective clothing to prevent injuries and fuel from coming in contact with your skin. Wrap a cloth around the connection before removing a fuel hose. Remove the hose connection carefully to release the pressure.
- Connect the fuel extracting device VAS 5190 ground strap to the vehicles ground strap.
-- Disconnect the fuel supply line -arrow-. To do so, press in the securing ring.
-- Connect the fuel extracting device VAS 5190 and fuel extracting adapter VAS 5190/3 to the fuel supply line.
-- Remove the rear bench seat. Refer to Removal and Installation .
-- Remove the cover from the fuel delivery unit.
-- Disconnect the connector -arrow-.
-- Install the test instrument adapter/DSO (5-pin) VAS 5565 between the connectors on the fuel delivery unit and cover.
-- Connect the remote control V.A.G 1348/3A to the test instrument adapter/DSO (5-pin) VAS 5565 and to battery positive (+).
This step allows the fuel pump to run when the engine is not running.
-- Remove the fuel cap from the fuel filler tube.
-- Operate the remote control V.A.G 1348/3A and the shut off valve on the fuel extracting device VAS 5190 until the fuel tank is empty.
Do not run the fuel pump dry.