Fastener Tightening Specifications
WARNING: This page is about a different variant/trim than selected.
| Component | Fastener Size | Nm | ||||||
|---|---|---|---|---|---|---|---|---|
| Catalytic Converter Heat Shield Bolt (2) | ||||||||
| -- Front Bolt | - | 10 | ||||||
| -- Rear Bolt | - | 5 | ||||||
| Crossmember to Underbody Nut | - | 20 | ||||||
| Exhaust Clamp Nut | - | 23 | ||||||
| Exhaust Manifold to Cylinder Head Nut (1) | - | 25 | ||||||
| Front Exhaust Pipe with Catalytic Converter to Exhaust Manifold Nut (1) | - | 23 | ||||||
| Front Exhaust Pipe with Catalytic Converter Suspended Mount to Subframe Bolt | - | 23 | ||||||
| Heat Shield to Exhaust Manifold Bolt | - | 10 | ||||||
| Intake Manifold Support to Cylinder Block Bolt | - | 25 | ||||||
| Muffler Suspended Mount to Body/Fuel Tank Bolt | - | 26 | ||||||
| Muffler Suspended Mount to Body Bolt | - | 23 | ||||||
| Oxygen Sensor | - | 55 | ||||||
| Oxygen Sensor Bracket to Cylinder Block Bolt (3) | - | 10 | ||||||
| Secondary Air Injection Pump Motor Bushing to Intake Manifold Support Nut | - | 10 | ||||||
| Secondary Air Injection Sensor 1 to Secondary Air Injection Pressure Pipe Bolt | - | 2 | ||||||
| Secondary Air Injection Solenoid Valve to Cylinder Head Bolt | - | 10 | ||||||
|
||||||||
Secondary Air Injection Pipe Bolt Tightening Sequence and Specification
-- Install the bolts -1 through 3- hand tight.
-- Tighten the bolts -1 through 3- in sequence to 10 Nm.