LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2005 >> Jetta TDI, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 27 (Clutches - 0A4 (Sedan) (A5 Platform)) >> 30 Clutch >> Removal And Installation >> Over Center Spring >> Removing

Over Center Spring: Removing

WARNING: This page is about a different variant/trim than selected.

-- Move the driver seat all the way back and raise the steering wheel to the highest position.

-- Remove the trim and the cover under the trim on the driver side. Refer to Removal and Installation .

-- Remove the wire guide -2- from the steering column.

Fig 1: Identifying Cable Ties, Cable Guide & Floor Vent
GWWN30-10001Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the footwell vents -3-. Refer to Removal and Installation .

There are different ways of securing the impact bolster support -1- in front of the clutch pedal -2-. The impact bolster support may look different than what is shown in the following illustrations.

Securing with Two Bolts 

Fig 2: Identifying Impact Bolster & Front Of Clutch Pedal
GWWN34-10315Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the impact bolster support bolts and support -1-.

Securing with One Bolt 

Fig 3: Identifying Impact Bolster & Bolt
GWWN30-10117Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the impact bolster support bolt -2- and support -1-.

-- Remove the damper -arrow- from the clutch pedal bracket, if equipped.

Fig 4: Identifying Bracket With Sound Absorber
GWWN30-10195Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the damper retainers -A-.

Fig 5: Identifying Damper Retainers
GWWN30-10188Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the damper.

-- Push the damper near the upper nut -1- above the clutch pedal -A- in the -direction of the arrow-.

Fig 6: Locating Damper Near The Upper Nut
GWWN30-10189Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the nut -2- and the bolt -5-, then remove the clutch pedal -1- from the bracket -3-.

Fig 7: Identifying Clutch Pedal, Mounting Bracket, Nut And Bolt
GWWA30-0125Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
NOTE:

The clutch pedal remains engaged in the master cylinder actuator rod.

-- Swivel the clutch pedal slightly downward and remove the over center spring -4- from the bracket.