Mounting Bracket: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal.

Some vehicles have a damper -arrow- over the clutch pedal bracket.

Fig 1: Identifying Bracket With Sound Absorber

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Replace the self locking nuts.

Replace the hose clamps

Allocate all components

There are different ways of securing the impact bolster support -1- in front of the clutch pedal -2-.

Fig 2: Identifying Impact Bolster & Front Of Clutch Pedal

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Securing with Two Bolts

-- Install the impact bolster support -1- and tighten the 2 bolts to specification. Refer to TIGHTENING SPECIFICATIONS .

Securing with One Bolt

Fig 3: Identifying Impact Bolster & Bolt

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the impact bolster support -1- and tighten the bolt -2- to specification. Refer to TIGHTENING SPECIFICATIONS .

Continuation for All

-- Attach the wire guide -2- to the steering column.

Fig 4: Identifying Cable Ties, Cable Guide & Floor Vent

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the footwell vents -3-. Refer to Removal and Installation .

-- Install the trim and the cover under the trim on the driver side. Refer to Removal and Installation .

-- Press the hose/line assembly -1- or plastic line into the master cylinder connection -4- with a new seal -2- until the clip -3- engages audibly.

Fig 5: Identifying Hose/Line Assembly, O-Ring, Master Cylinder Connection & Securing Clip

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Pull on the hose/line assembly or plastic line to make sure it is tight.

-- After removing the 3094 bring the return hose back to its original shape.

-- Bleed the clutch system. Refer to CLUTCH SYSTEM, BLEEDING .

-- Install the battery. Refer to Removal and Installation .

-- If removed, install the air filter housing. Refer to one of the following: