Clutch Pedal: Removing

WARNING: This page is about a different variant/trim than selected.

-- Move the driver seat all the way back and raise the steering wheel to the highest position.

-- Remove the trim and the cover under the trim on the driver side. Refer to Removal and Installation .

-- Remove the wire guide -2- from the steering column.

Fig 1: Identifying Cable Ties, Cable Guide & Floor Vent

GWWN30-10001

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the footwell vents -3-. Refer to Removal and Installation .

There are different ways of securing the impact bolster support -1- in front of the clutch pedal -2-. The impact bolster support may look different than what is shown in the following illustrations.

Fig 2: Identifying Impact Bolster & Front Of Clutch Pedal

GWWN34-10315

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Securing with Two Bolts

-- Remove the impact bolster support bolts and support -1-.

Securing with One Bolt

Fig 3: Identifying Impact Bolster & Bolt

GWWN30-10117

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the impact bolster support bolt -2- and support -1-.

Continuation for All

-- Remove the damper -arrow- from the clutch pedal bracket, if equipped.

Fig 4: Identifying Bracket With Sound Absorber

GWWN30-10195

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the retainers -A- for the damper.

Fig 5: Identifying Damper Retainers

GWWN30-10188

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the damper.

-- Push the damper near the upper nut -1- above the clutch pedal -A- in the -direction of the arrow-.

Fig 6: Locating Damper Near The Upper Nut

GWWN30-10189

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the nut -2- and bolt -5- and then remove the clutch pedal -1- from the bracket -3-.

Fig 7: Identifying Clutch Pedal, Mounting Bracket, Nut And Bolt

GWWA30-0125

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Swivel the clutch pedal slightly downward and remove the over center spring -4- from the bracket.

-- Unclip the clutch pedal from the master cylinder using T10005.

Fig 8: Identifying Pliers T10005 To Disengage Master Cylinder Operating Rod Mount

GWWA30-0118

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the clutch pedal.