LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2005 >> Jetta TDI, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 27 (Clutches - 0A4 (Sedan) (A5 Platform)) >> 30 Clutch >> General Information >> Determining Clutch Manufacturer >> Notes

Determining Clutch Manufacturer: Notes

WARNING: This page is about a different variant/trim than selected.

Either a "Sachs" or a "LuK" clutch may be installed.

It is possible to tell which clutch the vehicle has with the transmission installed:

-- Remove the noise insulation. Refer to Description and Operation .

There are some openings -arrows- between the engine -A- and the transmission -B- near the bottom of the oil pan.

Fig 1: Identifying Recesses Located Between Engine And Transmission
GWWN30-10068Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Check the outer contour of the flywheel through these openings.

-- The outer contour of the flywheel can also be inspected by removing the small cover plate -A-.

Fig 2: Identifying Flywheel Small Cover Plate Behind Right-Hand Flanged Shaft
GWWV34-3005Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.