Clutch Pedal Overview
WARNING: This page is about a different variant/trim than selected.
- Bulkhead
- With a mount for the bracket.
- Seal
- Always replace.
- Between the bracket and bulkhead.
- With self-adhesive.
- Attach to the bracket.
- Bracket
- For the clutch pedal mounting.
- Some equipment versions have a damper, refer to CLUTCH PEDAL OVERVIEW .
- Removing and installing, refer to MOUNTING BRACKET .
- Bolt
- Over Center Spring
- Removing and installing, refer to OVER CENTER SPRING .
- Bushing
- Pin
- Clutch Pedal
- Removing and installing, refer to CLUTCH PEDAL .
- Mount
- To remove and install, disconnect the master cylinder from the clutch pedal. Refer to CLUTCH PEDAL .
- Seal
- Always replace.
- Between the master cylinder and the bracket.
- Master Cylinder
- Remove and install after removing the bracket. Refer to MOUNTING BRACKET .
- Clutch Position Sensor -G476-
- Removing and installing, refer to CLUTCH POSITION SENSOR .
- Can be checked in "Guided Fault Finding" using the VAS 5051.
- The clutch position sensor is called the clutch pedal switch -F36-
- Clip
- The clip must be removed in order to remove/install the hose/line assembly.
- Supply Hose
- Rubber
- Made of plastic as of 12.05, refer to HYDRAULICS OVERVIEW .
- Nut, Self Locking
- 25 Nm
- Always replace.
- Quantity: 3
- For securing the bracket to the bulkhead.
- Nut
- 25 Nm
- Always replace.
- Jounce Bumper
- For the clutch pedal.