Clutch Overview, SACHS
WARNING: This page is about a different variant/trim than selected.
- Dual Mass Flywheel
- Removing and installing, refer to one of the following:
Diesel engines, refer to [For engine(s) BRM] Removal and Installation .
Gas engines, refer to [For engine(s) BGP, BGQ, CBTA, CBUA] Removal and Installation .
- Make sure it fits securely on the alignment pins.
- Keep the clutch lining contact surface free of grooves, oil and grease.
- Removing and installing, refer to one of the following:
- Clutch Plate
- Removing and installing, refer to CLUTCH, SACHS .
- Only replace together with the pressure plate.
- Installed position, refer to CLUTCH, SACHS .
- Pressure Plate
- With a adjustment mechanism.
- Removing and installing, refer to CLUTCH, SACHS .
- Check the ends of the diaphragm spring, refer to CLUTCH, SACHS .
- Checking the spring and rivet connections, refer to CLUTCH, SACHS .
- Only replace together with the clutch plate.
- Bolt
- M6 = 13 Nm
- M7 = 20 Nm
- Loosen and tighten in small steps and in a diagonal sequence.