LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2005 >> Jetta TDI, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 25 (Electrical Equipment - General Information (A4 Platform)) >> 97 - Wiring >> Wiring Harnesses and Connectors, Repairing >> Wiring harnesses, repairing >> Fiber optic cables

Fiber optic cables

WARNING: This page is about a different variant/trim than selected.
CAUTION: Fiber-optic cables on Volkswagen vehicles are not to be repaired. In the event of malfunction, the complete fiber-optic cable must be replaced. In this regard, observe the following measures:
  • Fiber optic cables are not to be kinked or excessively bent (bending radius must not exceed 25mm).
  • Fiber-optic cable must not be routed over sharp edges.
  • End pieces (lenses) must be kept free from contaminants, fingerprints etc.
  • Fiber-optic cables must not be heated.
  • A pair of fiber-optic cables must not be twisted together, nor should a single fiber-optic cable be twisted together with a copper wire conductor.
scientia non olet · About LEMON Manuals