Front and rear window washer system
WARNING: This page is about a different variant/trim than selected.
- Disconnect by pulling apart both halves of coupling.
- Reconnect by pushing both halves of coupling together until felt and heard to engage.
- Disconnect by turning lock ring - 1 - through 90 ° - arrow - and then pulling apart both halves of coupling.
- Reconnect by pushing both halves of coupling together and rotating locking ring - 1 - - arrow - until it engages.
- Disconnect by lifting lock ring - 1 - approx. 1 mm - arrow - and then pulling apart both halves of coupling.
- Reconnect by pushing both halves of coupling together and clipping locking ring - 1 - until it engages.
- Disconnect by lifting lock ring - 1 - in direction of - arrow - and then pulling apart both halves of coupling.
- Reconnect by pushing both halves of coupling together and clipping locking ring - 1 - until it engages.