LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2005 >> Jetta TDI, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 24 (Electrical Equipment (A4 Platform)) >> 97 Wiring >> Wiring harnesses and connectors, repairing >> Wiring harnesses and connectors, general repair measures

Wiring harnesses and connectors, general repair measures

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • Note CAN-Bus wiring repair measures. Refer to CAN-Bus wiring, repair measures  .
  • Soldering is not permitted!
  • Do not repair welded connections in the wiring harness. Fabricate and connect an appropriate overlay harness instead.
  • Wiring harness and connector repairs must only be performed using VAS 1978 Wiring Harness Repair Kit. Refer to VAS 1978 Instruction Manual.
  • Only the yellow repair cables and insulation tape supplied with VAS 1978 are to be used for wiring/connector repairs. The use of yellow repair wires and yellow insulation tape identifies that a repair has taken place.
  • All shielded wiring (Eg.: knock sensors, antenna etc.) are Not to be repaired! Replace complete wiring harnesses as necessary.
scientia non olet · About LEMON Manuals