Rear Window Defogger Switch -E15-, Emergency Flasher Switch -E3- and ASR/ESP Switch, removing and installing
WARNING: This page is about a different variant/trim than selected.
NOTE:
Switches cannot be removed using a screwdriver due to the strong springs in their engagement mechanisms.
Removal and installation is the same for all switches. ASR/ESP switch removal is described below:
Removing
CAUTION:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
- First remove driver's heated adjuster. Refer to Heated seat adjusters, removing and installing
- Reach behind the ESP switch using the tip of assembly tool T10034.
- Release the button for ESP -1- using assembly tool T10034 and remove from vent.
- Disconnect electrical connector.
- Remove switch -2- and -3- in the same manner if necessary.
Installing
Install in reverse order of removal.