LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2005 >> Jetta TDI, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 24 (Electrical Equipment (A4 Platform)) >> 96 Lights, Switches - Interior, Anti-theft >> Interior lights and switches >> Switches in instrument panel, removing and installing >> Notes

Switches in instrument panel, removing and installing: Notes

WARNING: This page is about a different variant/trim than selected.

Switches consists of a switch housing and trim plate with relevant symbol. The trim plate is clipped onto the switch housing. If the trim is released instead of the switch during removal, the trim must be re-clipped onto the switch housing afterwards.

Remove switches with connected wiring from instrument panel opening prior to disconnecting electrical connection on rear of switch.

If necessary, temporarily remove switch to the left of the switch to be removed/replaced to allow sufficient access to the wiring.

Switch blank-out covers (where applicable) are removed in the same manner as switches.

CAUTION:
  • Be careful not to damage instrument panel when removing switch. Protect trim in area of switch with adhesive tape before removing switch.
  • Do Not pry out switches from the side. Only pull out from the top.
scientia non olet · About LEMON Manuals