Instrument Panel Light Dimmer/Switch -E20-, removing and installing
WARNING: This page is about a different variant/trim than selected.
NOTE:
European-only market dimmer/switch that includes manual headlight beam adjuster is illustrated here. Procedure is the same for USA/CDN models.
Removing
CAUTION:
Before beginning repairs on the electrical system:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
- Apply tape to instrument panel in area around switch in order to protect instrument panel.
- Carefully pry out switch housing from installation frame using screwdriver as illustrated.
- Pull out switch and disconnect electrical connector.
Installing
- Connect electrical connector.
- Insert headlight adjuster in guide on mounting frame and press in.