Glove Box Light -W6-, removing and installing
WARNING: This page is about a different variant/trim than selected.
Removing
CAUTION:
Before beginning repairs on the electrical system:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
- Insert screwdriver behind lens and carefully pry outwards.
CAUTION:
During removal, ensure light switch-off lever (where applicable) is not damaged.
- Pull out lens with bulb holder and microswitch
- Disconnect electrical connection.
- Replace 12V/3W bulb as necessary
Installing
- Connect electrical connection.
NOTE:
- To ease illustration, glove compartment is shown removed.
- Where applicable, note orientation of switch when installing: light switch-off lever must be in down position.
- Insert lens with bulb holder and microswitch in glove box and clip-in.
Perform functional check of light and switch: Light must go out with glovebox lid closed.