Steering column switches, removing and installing
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Before beginning repairs on the electrical system:
- Obtain the anti-theft radio security code.
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
- Disconnect negative ( - ) battery terminal.
- When disconnecting and reconnecting battery terminals, observe all applicable Notes and torque specifications, as well as instructions on performing OBD program and electrical system function checks as specified in this article . Refer to Battery with fastened fuse holder, disconnecting and reconnecting .
CAUTION:
Special safety precautions apply to vehicles equipped with airbags. Refer to 69 - PASSENGER PROTECTION - AIRBAGS, SEAT BELTS .
Special tools and auxiliary items needed
- VAG 1331 Torque wrench (or equivalent 5 - 50 Nm)
Removing
- Disconnect battery. Refer to Battery with fastened fuse holder, disconnecting and reconnecting .
- Remove driver's airbag
Refer to 69 - PASSENGER PROTECTION - AIRBAGS, SEAT BELTS
- Remove steering wheel
Refer to 69 - PASSENGER PROTECTION - AIRBAGS, SEAT BELTS
- Remove airbag spiral spring/return spring with slip ring
Refer to 69 - PASSENGER PROTECTION - AIRBAGS, SEAT BELTS
CAUTION:
Heed special procedure for spiral spring etc. removal on vehicles equipped with ESP.
- Loosen clamping bolt for steering column switch and remove steering column switch.
Installing
Install in reverse order of removal, noting the following
- Install airbag spiral spring/return spring with slip ring
Refer to 69 - PASSENGER PROTECTION - AIRBAGS, SEAT BELTS
- Install steering wheel
Refer to 69 - PASSENGER PROTECTION - AIRBAGS, SEAT BELTS
- Install driver's airbag
Refer to 69 - PASSENGER PROTECTION - AIRBAGS, SEAT BELTS
- Reconnect battery. Refer to Battery with fastened fuse holder, disconnecting and reconnecting .