Horn contact plate, removing and installing
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Special safety precautions apply to vehicles equipped with airbags. Refer to 69 - PASSENGER PROTECTION - AIRBAGS, SEAT BELTS .
Removing
- Disconnect battery. Refer to Battery with fastened fuse holder, disconnecting and reconnecting .
- Remove driver's airbag.
Refer to 69 - PASSENGER PROTECTION - AIRBAGS, SEAT BELTS
- Remove screws -arrows-.
- Disconnect electrical connection and remove contact plate.
Installing
Install in reverse order of removal, noting the following:
NOTE:
Ensure metal contact surfaces of contact plate as well as contact pins in steering wheel -arrows- are clean to metal.
- Reconnect battery. Refer to Battery with fastened fuse holder, disconnecting and reconnecting .