Rear light housing - Golf, removing and installing
WARNING: This page is about a different variant/trim than selected.
Removing
CAUTION:
Before beginning repairs on the electrical system:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
- Remove rear luggage compartment side panel trim (left or right):
Refer to 70 - INTERIOR TRIM
- Remove nuts -arrows- (Qty. 3) and remove housing.
- Remove bulb holder. Refer to Rear light bulb holder - Golf/Jetta, removing and installing
Installing
- Install bulb holder. Refer to Rear light bulb holder - Golf/Jetta, removing and installing
- Insert housing into body opening.
- Tighten nuts (3 Nm).
- Install applicable rear luggage compartment side panel trim.