Headlights, removing and installing
WARNING: This page is about a different variant/trim than selected.
Removing
CAUTION:
Before beginning repairs on the electrical system:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
- Remove front bumper
Refer to 63 BUMPER
- Remove screws -1-.
- Remove headlight trim -2-.
- Remove screws -3-.
- Remove screws -1-.
- Disconnect electrical connections.
- Pull headlight housing out forward.
Installing
Install in reverse order of removal.
- Check and adjust headlight if necessary. Refer to Headlights, adjusting .