Parking Light/Turn Signal (dual filament) bulb, replacing
WARNING: This page is about a different variant/trim than selected.
Removing
CAUTION:
Before beginning repairs on the electrical system:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
- Release spring clip -arrow- and remove sealing cover.
- Turn bulb holder -arrow- to left and pull out of housing.
- Remove bulb from the holder.
Installing
CAUTION:
Do not touch glass portion of bulb with bare hands. Even the smallest amount of moisture and/or contaminants from fingers that evaporates on the bulb during operation can cause the glass to cloud over.
Install in reverse order of removal.
NOTE:
When installing, ensure bulb holder engages in bulb housing.
- Install sealing cover.
- Check turn signal (bulb) function.