Fog Light bulb -L22- / -L23-, replacing

WARNING: This page is about a different variant/trim than selected.

Removing

CAUTION:

Before beginning repairs on the electrical system:

Switch off all electrical consumers.
Switch ignition off and remove ignition key.

Fig 1: Releasing Spring Clip (Fog Light, Jetta)

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Release spring sealing cover -arrow- and remove.

Fig 2: Identifying Electrical Connector, Retaining Clip, Lugs & Bulb (Fog Light, Jetta)

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect electrical connector -1- from bulb.
Push retaining clip -2- over lugs -3- and release.
Pull bulb -4- out of reflector.

Installing

CAUTION:

Do not touch glass portion of bulb with bare hands. Even the smallest amount of moisture and/or contaminants from fingers that evaporates on the bulb during operation can cause the glass to cloud over.

Insert new bulb so lugs on bulb plate align with cut-outs in reflector.
Connect electrical connector -1-.
Install sealing cover.
Check fog light (bulb) function.