Low Beam Headlight bulb -M29- / -M31-, replacing: Removing
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Before beginning repairs on the electrical system:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
- Release spring clip -arrow- and remove sealing cover.
Fig 2: Identifying Electrical Connector, Retaining Clip, Lugs & Bulb (Low Beam Headlight Bulb, Golf)
- Disconnect electrical connector -1- from bulb.
- Push retaining clip -2- over the lugs -3- and release.
- Pull bulb -4- out of reflector.