"Aero-wiper" blades, removing and installing
WARNING: This page is about a different variant/trim than selected.
"Aero-wiper" system installed as a running change during m.y. 2002.
Removing
CAUTION:
- To ensure proper wiper performance, only grab/lift Aero-wiper blades at the mounting pivot on wiper arm when removing and installing.
- Driver and passenger wiper blades are different lengths. Damage will result if wiper blades are interchanged.
- Bring wiper arm to park position.
- Switch off all electrical consumers, switch off ignition and remove ignition key.
- Lift Aero-wiper blade/arm assembly from windshield, noting CAUTION! above.
- Tilt wiper blade -1 on mounting pivot in direction of -arrow A- until it reaches stop.
- Detach wiper blade from mounting pivot in direction of -arrow B-.
Installing
- Insert wiper blade onto wiper arm mounting pivot -arrows-.
- Engage blade by tilting on pivot until blade is parallel with arm.
- Return arm/blade assembly to windshield, noting CAUTION! above.