Rear lid preparation

WARNING: This page is about a different variant/trim than selected.

Cut installation template as indicated and paste it to vehicle rear lid following illustrated dimensions.

NOTE:

Jetta 2004 Rear Spoiler Installation Template can be found and printed in: Library/Additional Information; Other Topics, Jetta 2004 Rear Spoiler Installation Template

Fig 1: Identifying Template Gray Shapes

GW00003672

Courtesy of VOLKSWAGEN UNITED STATES, INC.

With a soft pencil or crayon, draw outline of gray shapes - a - directly on vehicle surface
Drill holes to rear lid as indicated on Installing Template
Remove Installing Template
Apply scotch tape to outer borders of outlined surfaces to mask them before primer application

Clean thoroughly with alcoholic cleaner and then apply primer to outlined surfaces (three surfaces) on top of rear lid - a - and allow to dry