Releasing gas from gas-filled strut
WARNING: This page is about a different variant/trim than selected.
- Clamp gas-filled strut in vice area - x - = 50 mm (2 in.).
CAUTION:
Clamping must only be done in this area, otherwise there is a risk of an accident.
- Using saw, cut into cylindrical part of strut at point within first third of cylinders length (measured from cover edge at piston rod end of cylinder).
NOTE:
- Always wear eye protection when performing this procedure.
- Cover area of sawn-off portion with a clean rag.
- Dispose of fluid and cleaning rag in a proper manner.