P.A.S. power steering pump, vehicles with low mounted power steering pump, removing and installing: Removing

Fig 1: Noise Insulation And Bolts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove noise insulation.

Fig 2: Loosen Belt Pulley Hex Socket Head Bolt

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Loosen belt pulley hex socket head bolt.

Counter-hold with a hex key if necessary.

Fig 3: Slacken The Ribbed V-Belt By Swivelling The Tensioner

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Swivel the tensioner in direction of arrow to slacken the ribbed V-belt.
• Identify direction of rotation of the poly-V belt
• Remove ribbed belt.
• Remove belt pulley hex. socket head bolt.

Fig 4: Suction Hose Clamped Off With Hose Clamps

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Clamp off suction hose with Hose Clamps Up to 25 mm dia. 3094.
• Spring clamp - 3  - and pull off intake hose

Use assembly tool for spring-type clip pliers VAS 5024 for this.

• Remove banjo bolt - 4  -.
• Close off the pressure line with a plastic bag or similar.
• Remove hex bolts - 1  - and - 2  -.
• Take out pump.