Wheel bearing/wheel hub on vehicles with drum brakes, removing and installing: Installing
WARNING: This page is about a different variant/trim than selected.
- Install wheel bearing/wheel hub unit as far as possible on stub axle.
- Installation Sleeve wheel Brg. 3420 and pull wheel bearing/wheel hub unit on to stop.
Make sure that the hubs/wheel bearing unit does not tilt!
- Remove Installation Sleeve wheel Brg. 3420.
- Use a new 12-point nut - A - and tighten to 175 Nm.
- Install the brake drum.
- Drive in dust cap.
NOTE:
- Always replace dust caps.
- Damaged dust caps allow ingress of moisture, always use the tool illustrated. Always use tool illustrated to reduce chance of damage to dust cap.
Further installation in reverse order
- Install and fasten wheel → Torques for wheel bolts, tightening .